Sony MZ-B50 MP3 Player User Manual


 
10-GB
If the recording does not start
Make sure the recorder is not locked
(page 25).
Make sure the MD is not record-protected
(page 42).
Premastered MDs cannot be recorded over.
Notes
For long recordings, it is recommended that
you power the recorder from a house current
using an optional AC power adaptor AC-
E30HG (page 32).
The lid will not open during recording or until
TOC Edit disappears from the display after
the recording has completed.
If the power supply is disrupted (i.e. the
batteries are removed or becomes exhausted
or the optional AC power adaptor is
disconnected) during a recording operation, or
while TOC Edit appears in the display, then
it will not be possible to open the lid until
power is restored.
Data Save or TOC Edit flashes while data
of the recording (the tracks start and end
points, etc.) is being recorded. Do not move or
jog the recorder or disconnect the power
source while the indication is flashing in the
display. If you do, the material recorded up to
that point will not be saved to the disc.
When you record through the microphones,
the various sounds made by the recorder will
also be recorded.
Do not connect an optional AC power adaptor
during a recording operation if you are
operating the recorder on battery power. If you
do, the material recorded up to that point will
not be saved to the disc
The built-in microphones do not operate
whenever an optional microphone is
connected into the MIC (PLUG IN POWER)
jack on the recorder.
The built-in microphones do not operate
whenever an optical cable or a line cable is
connected into the LINE IN (OPTICAL) jack
on the recorder.
Make sure not to switch the recording mode
while recording. If you do, recording may not
occur.
Remove the MD xSTOP to stop recording and open the lid. (The lid
does not open while TOC Edit flashing in the
display.)
1)
The REC indicator flashes during recording pause. Track marks are not added while recording with
microphones, even when the recorder is paused.
To Press