Filter
Top Products
ICD-SX700/SX800 4-127-580-11(1)
15
GB
Getting Started
When you use the IC recorder for the
rst time, or after you have not used the
IC recorder for a certain period of time,
it is recommended that you charge
the batteries continuously until “
” is
displayed.
If the battery indicator is not displayed,
charging has not been done properly.
Proceed from step 1 again.
* This is an approximation for the time it takes
to charge from no remaining battery power
to full battery power at room temperature.
It varies depending on the remaining power
and the condition of the batteries. It also
takes more time if the temperature of the
batteries are low, or if the batteries are
charged while you are transferring data to
the IC recorder.
Disconnecting the IC
recorder from your
computer
Follow the procedures below; otherwise,
data may be damaged.
1 Make sure that the operation
indicator is not ashing.
2 Disconnect the USB connecting
cable connected to the IC recorder
from the USB connector of the
computer.
On the Windows screen, left-click
“Safely Remove Hardware” on the
taskbar, and click “Safely remove USB
Mass Storage Device.”
On the Macintosh screen, drag the “IC
RECORDER” on the desktop to “Trash”
and drop it there.
For details on disconnecting the
IC recorder, refer to the operating
instructions supplied with your
computer.