Filter
Top Products
ICD-SX700/SX800 4-127-580-11(1)
115
GB
Troubleshooting
Symptom Remedy
The “UPDATING
DATABASE...” display does
not disappear.
If the IC recorder is required to process excessive amount
of data, “UPDATING DATABASE...” may be displayed for an
extended period of time. This is not a malfunction of the IC
recorder. Wait until the message disappears.
You cannot connect the IC
recorder to a computer.
Refer to the help les of the Digital Voice Editor 3 software.
It takes time to start up
the IC recorder.
When there are many messages stored in the IC recorder, it
may take time to start up. This is not a malfunction. Wait until
the stop mode display appears.
The IC recorder does not
operate correctly.
Take out the batteries and insert them again (page 14).
The IC recorder does not
operate.
You may have formatted the memory of the IC recorder using
the computer. Use the IC recorder formatting function to
format the memory (page 90).
The IC recorder is not
recognized by your
computer.
A folder/le cannot be
transferred from your
computer.
Disconnect the IC recorder from your computer and reconnect
it.
Do not use a USB hub or USB extension cable other than the
supplied USB connecting cable. Connect the IC recorder to
your computer using the supplied USB connecting cable.
Operation is not guaranteed if you use any system
requirements other than those described on page
94.
Depending on the USB connector position, the IC recorder
may not be recognized. If this happens, try another connector.
The le transferred from
your computer cannot be
played back.
The le format may dier from those that can be played back
using the IC recorder (.mp3/.wma /.msv/.wav) (page 101).
Check the le name.