Filter
Top Products
E-6
EN
Remote control
■ Battery installation
1
Open the battery cover.
2 Insert the supplied battery according to the terminal
indicated in the battery compartment.
When inserting or removing the battery, push it towards
the (–) battery terminals.
3 Close the cover.
Caution:
● Remove the battery if the unit will not be used for a
long period of time. This will prevent potential damage
due to battery leakage.
● Do not use rechargeable battery (nickel-cadmium
battery, etc.).
● Installing the battery incorrectly may cause the unit to
malfunction.
● Batteries (battery pack or batteries installed) shall not
be exposed to excessive heat such as sunshine, fire
or the like.
Notes concerning use:
● Replace the battery if the operating distance is reduced
or if the operation becomes erratic. Purchase an “AA”
size battery (UM/SUM-3, R6, HP-7 or similar).
● Periodically clean the transmitter on the remote control
and the sensor on the unit with a soft cloth.
● Exposing the sensor on the unit to strong light may
interfere with operation. Change the lighting or the
direction of the unit if this occurs.
● Keep the remote control away from moisture, heat,
shock, and vibrations.
■ Test of the remote control
Check the remote control after checking all the connections.
Point the remote control directly at the remote sensor on
the unit. The remote control can be used within the range
shown below:
BLUETOOTH
PAIRING
Remote sensor
0.2 m - 6 m
(8” - 20’ )
General control
BLUETOOTH
PAIRING
■ To turn the power on
Press the ON/STAND-BY button to turn the power on.
After use:
Press the ON/STAND-BY button to enter the power stand-
by mode.
■ Display brightness control
To dim the display brightness, press the DIMMER button
on the remote control.
Dimmer 1
Dimmer 2
Dimmer Off
(Display is dim).
(Display is bright).
(Display gets dimmer).
■ Volume auto fade-in
If you turn off and on the main unit with the volume set to
28 or higher, the volume starts at 16 and fades in to the
last set level.
■ Volume control
Press VOLUME (+ or -) on the main unit or VOL +/- on the
remote control to increase or decrease the volume.
■ Direct key power on function
When you press any of the following buttons, the unit
turns on.
● iPod, CD/USB, AUDIO IN, TUNER, BLUETOOTH
/ ,
iPod
/ , CD / , USB / on the remote control: Selected
function is activated.
●
/ button on the main unit: The unit turns on and
playback of the last function will start (CD, TUNER,
USB, iPod, AUDIO IN, Bluetooth)
■ Auto power on
During BT Standby mode, when music is played from your
device, the unit will automatically power on when:
● The Bluetooth connection has been set up between the
main unit and your device and they remain connected.