Removing the front panel
1 Press EJECT to open the front panel.
2 Slide and remove the front panel to-
ward you.
Takecare not to grip it too tightly or to drop
the front panel and protect it from contact
with water or other fluids to prevent perma-
nent damage.
3 Put the front panel into the protective
case provided for safe keeping.
Attaching the front panel
1 Make sure the inner cover is closed.
2 Replace the front panel by clipping it
into place.
About the demo mode
This unit features two demonstration modes.
One is the reverse mode, the other is the fea-
ture demo mode.
! You cannot cancel a demo mode when the
front panel is open.
! When the front panel is open, BAND,
ENTERTAINMENT, EQ and EQ-EX are not
available.
Important
The red lead (ACC)of this unit should be con-
nected to a terminal coupled withignition switch
on/off operations. If thisis not done, the vehicle
battery may be drained.
Reverse mode
If you do not perform an operation within
about 30 seconds, screen indications start to
reverse, and then continue reversing every 10
seconds. Pressing BAND when power to this
unit is turned off while the ignition switch is
set to ACC or ON cancels the reverse mode.
Press BAND again to start the reverse mode.
Feature demo
The feature demo automatically starts when
power to this unit is turned off while the igni-
tion switch is set to ACC or ON. Pressing
ENTERTAINMENT during feature demo opera-
tion cancels the feature demo mode. Press
ENTERTAINMENT again to start the feature
mode. Remember that if the feature demo
continues operating when the car engine is
turned off, it may drain battery power.
Before You Start
En
7
English
Section
01