Filter
Top Products
Listening to the radio
1
2
3
4
5
These are the basic steps necessary to operate
the radio. More advanced tuner operation is
explained starting on the next page.
Important
If you are using thisunit in North, Central or
South America, reset theAM tuning step (see
Setting the AM tuningstep on page 50).
1 Band indicator
Shows which band the radio is tuned to, AM
or FM.
2 Preset number indicator
Shows which preset has been selected.
3 Stereo (ST) indicator
Shows that the frequency selected is being
broadcast in stereo.
4 LOC indicator
Shows when local seek tuning is on.
5 Frequency indicator
Shows to which frequency the tuner is
tuned.
1 Press SOURCE to select the tuner.
Press SOURCE until you see Tuner displayed.
2 Press BAND to select a band.
Press BAND until the desired band is dis-
played, FM1, FM2, FM3 for FM or AM.
3 To perform manual tuning, push
Multi-Control left or right.
The frequencies move up or down step by
step.
4 To perform seek tuning, push and hold
Multi-Control left or right for about one
second and release.
The tuner will scan the frequencies until a
broadcast strong enough for good reception is
found.
# You cancancel seek tuning by pushing
Multi-Control left or right.
# If you push and holdMulti-Control left or
right you can skipstations. Seek tuning starts as
soon as you releaseMulti-Control.
Tuner
En
14
Section
04