Filter
Top Products
3 Touch c or d to select a desired level.
Each time you touch c or d selects level in
the following order:
LOW (low)MID (mid)HIGH (high)
Using subwoofer output
This unit is equipped with a subwoofer output
which can be turned on or off.
! When the subwoofer output is on, you can
adjust the cut-off frequency and the output
level of the subwoofer.
1 Touch SUB WOOFER on the audio func-
tion menu.
# When the subwoofer controller settingis
FULL, you cannot select SUB WOOFER.
2 Touch c to turn subwoofer output on.
# To turn subwoofer output off, touch d.
3 Touch b and then touch c or d to se-
lect the phase of subwoofer output.
Touch d to select normal phase and
NORMAL appears in the display. Touch c to
select reverse phase and REVERSE appears in
the display.
4 Touch b and then touch c or d to ad-
just the output level of the subwoofer.
Each time you touch c or d increases or de-
creases the level of the subwoofer. +6 6 is
displayed as the level is increased or de-
creased.
5 Touch b and then touch c or d to se-
lect cut-off frequency.
Each time you touch c or d selects cut-off fre-
quencies in the following order:
50Hz80Hz125Hz
Only frequencies lower than those in the se-
lected range are outputted from the sub-
woofer.
Boosting the subwoofer level
You can easily boost the subwoofer bass level
by repeatedly pressing BOOST button. If the
subwoofer is set to OFF, pressing BOOST but-
ton automatically sets the subwoofer to ON.
% Press BOOST button to increase the
subwoofer level.
The subwoofer level 0-+6 is shown in the dis-
play.
# To decrease the level, pressBOOST button
and hold. The subwoofer level is reset to 0 and
then you can start again.
Note
You can also select the subwoofer level in the
auido menu. Refer to Usingsubwoofer output on
this page.
Using nonfading output
When the nonfading output setting is on, the
audio signal does not pass through this units
low pass filter (for the subwoofer), but is out-
putted through the RCA output.
1 Touch NON FADING on the audio func-
tion menu.
# When the subwoofer controller settingis only
FULL, you can select NON FADING. (Refer to
page 89.)
2 Touch a to turn non fading output on.
# To turn non fading outputoff, touch b.
3 Touch c or d to adjust the output level
of the non fading.
Each time you touch c or d increases or de-
creases the level of the non fading. +6 6 is
displayed as the level is increased or
decreased.
Audio Adjustments
En
71
Section
16
Audio Adjustments