Filter
Top Products
41
Error messages (continued)
Monitor display Description
VTR operation
E-20
DEW
If condensation is detected, the error number flashes and the
unit transfers to eject mode. The drum rotates after the
cassette is ejected to eliminate the condensation.
Once the unit is released from condensation status, the error
message display is cleared and the VTR is able to be used.
• If condensation is detected in the eject mode, the drum
starts rotating as soon as it is detected.
• If condensation is detected when the cassette has been
inserted, the drum rotation is stopped, and after the tape
is ejected, the drum starts rotating.
Leave the power on and
wait.
E-29
FRONT LOAD
MOTOR
The unit switches to eject mode and if the cassette fails to
move up within 6 seconds, this error number flashes on the
display.
Note:
If the cassette does not move down inside the machine
even when 6 seconds have elapsed since the cassette was
inserted, the VTR is transferred to the eject mode.
Set the POWER switch
to OFF and then to ON
again.
E-31
LOADING
MOTOR
If the unloading operation is not completed within 6
seconds, this error number flashes on the display.
Note:
When the loading operation is not completed within 6
seconds, the VTR is transferred to the eject (unloading)
mode.
Set the POWER switch
to OFF and then to ON
again.
EJECT
STOP
STOP
E-35
SERVO CONTROL
ERROR
If there is no response from the servo microcomputer for 1
second or more, this error number flashes on the display.
Set the POWER switch
to OFF and then to ON
again.
STOP
E-37
SERVO COMM
ERROR
If 10 seconds or more elapses and the servo
microcomputer has not followed orders issued by the
system control microcomputer, this error number flashes on
the display.
Set the POWER switch
to OFF and then to ON
again.
STOP
E-51
FRONT LOAD
ERROR
If the take-up reel rotates without engaging for a specific
period of time during the start or end processing operation
while loading is underway (half position), this error number
flashes on the display.
Set the POWER switch
to OFF and then to ON
again.
E-52
W-UP REEL
NOT ROTA
If the take-up reel fails to take up the tape while the tape is
traveling in the state where the total amount of the tape has
not yet been detected after the cassette was inserted, this
error number flashes on the display.
Set the POWER switch
to OFF and then to ON
again.
STOP
STOP
Corrective action
Error messages
E-00
(SERVO NOT
LOCKED)
This appears when the servo is not locked for
three or more seconds during playback or
recording.
Check the tape. It is
possible that a tape
recorded by a system
other than 525/60 has
been loaded.
E-01
(LOW RF)
This appears when an envelope level
approximately one-third of the normal level has
been detected for more than one second during
playback or recording.
Clean the video heads.
E-02
(HIGH ERROR
RATE)
This appears when the error rate has increased to
the extent that correction or interpolation was
applied to either the video or audio playback
signals.
Clean the video heads.
Operation
continues.
Operation
continues.
Operation
continues.
Monitor display Description
Priority VTR operation
Corrective action
(Low)