Filter
Top Products
9-16 User’s Manual
Troubleshooting
Disk drive
For information on disk care refer to Chapter 4, Operating Basics.
Real Time Clock
Cannot write correctly If you have trouble writing, make sure you are
observing the following precautions:
■ Use only media recommended by TOSHIBA.
■ Do not use the mouse or keyboard during
writing.
■ Use only the software supplied with the
computer for recording.
■ Do not run or start other software during
writing.
■ Do not jar the computer during writing.
■ Do not connect/ disconnect external devices
or install/remove internal cards during writing.
If problems persist, contact your dealer.
Problem Procedure
Problem Procedure
Some programs run
correctly, but others do
not
The software or hardware configuration may be
causing a problem. Make sure the hardware
configuration match’s your software’s needs.
You cannot access the
disk drive
Try another disk. If you can access this disk, the
original disk (not the disk drive) is problem.
If problems persist, contact your dealer.
Problem Procedure
The following
message is displayed
on the LCD:
RTC battery is low or
CMOS checksum is
inconsistent. Press
[F2] key to set Date/
Time.
The RTC battery charge has become exhausted,
you should set the date and time in within the
BIOS setup screen through the following steps:
1. Press [F1] key. BIOS setup will boot up.
2. Press [F2] to set the date in [System Date].
3. Press [F2] to set the time in [System Time].