Filter
Top Products
19
206-4207
Installer Menu
Use the Installer Menu to set up, change, or view operational settings. This section describes
how to access, use, and exit the Installer Menu from the TV itself; however, you should also refer
to the Installer Menu descriptions in this document if you are conguring the TV using LG’s FTG
conguration software.
Refer to the table on pages 21 and 22 for brief descriptions of Installer Menu items. More detailed
descriptions follow the table listing.
Accessing the Installer Menu
1. Turn ON the TV.
If the Express Script Installer Menu Wizard appears on the screen when you turn ON the TV,
use the Up/Down arrow keys on the Installer Remote to select Exit Express Script, and
press OK (Enter) to exit the wizard.
2. Using an Installer Remote, press MENU repeatedly until the on-screen display of the TV setup
menus (if the TV is in Pass-through Mode) or the Function Menu (if the TV is not in Pass-through
Mode) no longer toggles, and then press the Installer Menu entry sequence (e.g., 9-8-7-6) + OK
(Enter) to access the Installer Menu.
Note: The default Installer Menu entry sequence is “9876;” however, if Installer Menu item 000
INSTALLER SEQUENCE has been modied, the entry sequence may be one of three addi-
tional options. See Installer Menu detailed descriptions for further information.
The Installer Menu opens with item 000 INSTALLER SEQ 000.
Typical Installer Menu
xxLQ630H PTC INSTALLER MENU
CPU-CTV
000 INSTALLER SEQ 000
UPN 000-000-000-000 ASIC D279
PTC V1.00.029 CPU V3.50.00
Note: The Installer Menu header will vary depending on the TV you are setting up.
Note: If the password (entry sequence) is not entered or registered correctly, you will see the
message “ENTER PASSWORD 0000” at the top of the screen instead of the Installer Menu
header. Once you re-enter the correct password (e.g., press 9-8-7-6 + OK [Enter]), the Installer
Menu will display.
Note: If the TV is not in Pass-through Mode, the Installer Menu is accessible as read-only.