Filter
Top Products
11
206-4207
Upon launching, the Express Script Installer Menu Wizard prompts
you to select a menu mode. Use the Up/Down arrow keys on the
Installer Remote to select the appropriate option:
• Select/highlight Express Script in order to proceed with the wizard.
Then, press OK (Enter) on the Installer Remote.
• Select/highlight Exit Express Script to exit the wizard. Then, press
OK (Enter) on the Installer Remote.
The following procedure describes the Express Script Installer Menu
Wizard steps. You can select the “Back” button, where available, to
check previous settings, as necessary.
1. Select the tuning band.
Use the Left/Right arrow keys on the Installer Remote to select the
appropriate tuning band: Cable Standard (default), Cable HRC,
Cable IRC, or Air. When you have made your selection, use the
arrow keys to select Next, and then press OK (Enter).
2. Select the Aux inputs.
If you simply select Next and press OK (Enter) in this step, default
values will be used. Otherwise, use the Up/Down arrow keys to
select the desired Aux input option(s).
• To customize settings, select Customize inputs and press OK
(Enter). Aux input options are displayed in a pop-up window. Use
the arrow keys to select the input(s) to enable or disable. When
you are nished, press OK (Enter) or MENU on the Installer
Remote. Then, continue with step 3.
• To use default values, select Use default values and press OK
(Enter). Then, continue with step 3.
Express Script Installer Menu Wizard
The Express Script Installer Menu Wizard guides you through the process of setting up the essential
items for most hospital TV viewing applications. The wizard will appear on the screen each time the TV
is turned ON, until conguration is completed or the wizard is exited. Use the Installer Remote to make
selections and complete each step.
Note: If previously completed or exited, the Express Script Installer Menu Wizard can be re-activated
from the Installer Menu—set Installer Menu item 117 FACT DEFAULT to 1 to initiate the Express Script
Installer Menu Wizard. See the “Installer Menu” section of this document for further information.
Note: If you plan to create a customized Master TV Setup using the procedure described on pages 15 to
18, transfer (Teach) a Master TV Setup to a Target TV, or congure a TV for FTG Mode of operation, be
sure to exit the Express Script in order to avoid setup conicts that may cause the TV to malfunction.
Note: If you bypass the Express Script, pillow speaker functionality will not be enabled
unless you set Installer Menu item 027 HOSPITAL MODE appropriately. See the “Installer
Menu” section of this document for further information.
Note: If you opt to exit the Express Script Installer Menu Wizard at any time while it is in
progress, any settings made will not be retained.
(Continued on next page)
Installer Menu Wizard
Select Menu Mode
Express Script
PTC: V1.00.029 CPU: V03.50.00.01 ASIC: D279
OK
Which menu mode will you be using?
Exit Express Script
Installer Menu Wizard
Step 2. Aux Input
Customize inputs.
PTC: V1.00.029 CPU: V03.50.00.01 ASIC: D279
Back
Next
1
►
2
►
3
►
4
►
5
►
6
►
7
►
8
Which inputs will you be using?
Use default values.
Installer Menu Wizard
Step 1. Tuning Band
Cable Standard
PTC: V1.00.029 CPU: V03.50.00.01 ASIC: D279
Back
Next
1
►
2
►
3
►
4
►
5
►
6
►
7
►
8
Which tuning band would you like to use?
►
►
OK
Exit Express Script
CC
OK
Exit Express Script
CC