Filter
Top Products
7
Manually
This is only necessary if you do not wish to wait for
the WWVB reception. All manual set time and date
settings will be over-ridden by the reception of the
WWVB signal. In most cases all that needs to be set
different from the default (factory) settings is the
time zone (section “D” following) and the pressure
(section “K” following), which must be set to your
current pressure.
PROGRAMMING SEQUENCE Default (Factory) Setting
A. LCD Contrast LCD 5
B. 12/24-hour Mode 12h
C. Hour Setting 12: AM
D. Minute Setting :00
E. Time Zone Setting -5 (EST)
F. Daylight Saving Time ON/OFF 1 (ON)
G. Year Setting 2000
H. Month Setting 1 (January)
I. Date Setting 1
J. Degree Setting °F / °C °F
K. Weather Forecast Sensitivity 3
L. Pressure Readout rel inHg
M. Setting the Pressure 29.91
A. SETTING THE LCD CONTRAST
1. Press and hold the “MODE/SET” button for 5
seconds or until “Lcd 5” flashes in the time Lcd.
2. There are 7 Lcd contrast levels to choose from –
“Lcd 1” is the lightest and “Lcd 7” is the darkest.
3. Press the “CH/+” button to toggle through to your
desired setting.
4. Press the “MODE/SET” button to confirm and
advance to 12/24 hour time setting.