Filter
Top Products
19
3. To view the minimum and maximum temperature
select which remote sensor to read data from and then
press and release the “MIN/MAX/RESET” button.
4. Pressing this button once will display the minimum
temperature, minimum humidity and the date and
time the data was recorded. Pressing this button a
second time will display the same data for the
maximum recordings.
I. MOUNTING
Note: Before permanently mounting ensure that the weather
station is able to receive both the WWVB signal as well as the
signal from the remote sensor. Extreme and sudden changes in
temperature will decrease the accuracy of the weather station.
Changes in elevation will result with inaccurate weather
forecasting for the next 12 to 24 hours. These changes will require
a 12 to 24 hour wait before obtaining reliable data.
A. The Weather Station
1. Mounting using the table stand
a. The indoor temperature station comes with the
table stand already mounted. If you wish to use
the table stand all that is required is to place the
weather station in an appropriate location.
2. Mounting on the wall
a. Remove the table stand. To do this pull down on
the stand from the rear and rotate forward.
b. Fix a screw (not included) into the desired wall
leaving approximately 3/16” (5mm) extending
from the wall.
c. Place the weather station onto the screw using
the hanging hole on the backside. Gently pull
the weather station down to lock into place.