Filter
Top Products
Basic Operations
25
Using the buttons on the VCR:
Press PLAY and then REW to search in reverse.
Press PLAY and then F.FWD to search ahead.
Press PLAY again to return to normal playback.
Using the SHUTTLE dial on the remote control:
Press PLAY and turn the dial to the far right or left to search forward
and backward.
Searching with the Time Counter
During playback (and recording), a counter keeps track of how many
hours, minutes, and seconds the tape has run. When you first start
playback, the counter shows briefly in the TV screen's upper right corner.
When you want to check the counter during playback, there are several
ways to do it. Pressing DISPLAY will cycle you through the three options.
Press DISPLAY just once to see the counter, mode, time, and date on
the screen for 5 seconds.
Before the 5 seconds is up, press DISPLAY a second time to see just
the counter. It will stay on the screen.
Press DISPLAY a third time to to see the counter on the VCR display as
well.
Press DISPLAY a fourth time to end the on-screen display.
The linear time counter operates only if there is something recorded on
the tape.
The counter changes to 0:00:00 when the tape is ejected.
Marking with the Time Counter
If there is one part of the video that you know you are going to want to
return to, you can set the time counter to memorize that spot. Begin in
either STOP or PLAY mode.
Press DISPLAY twice to show the counter on the TV screen.
Begin recording or playing back a tape. Notice the counter remains on the
screen.
At the point that you want to go back to, press CLEAR. This resets the
counter to 0:00:00.
Press STOP when you are done recording or playing back the tape.
Press DISPLAY again and an "M" will display below the counter on the
TV screen: This indicates that the counter's memory function is engaged.
Now when you rewind the tape, it will automatically stop at the spot where
you cleared the counter. (Notice it moves just past the marker and then
back to it.) Press PLAY to watch the tape from that preselected spot.
Press DISPLAY to take the counter display off. The spot is still in
memory until you set a new one or until the tape is ejected.
Jump Forward or Backward with GO-TO
Using the time counter, you can search for a spot a certain number of
minutes before or after your current position on the tape.
Press STOP, if tape is playing, and press DISPLAY, then press 8 button to
bring up the Set Go-To Time screen:
Select minutes by pressing buttons 0 to 9 - one digit for hours, then two