Filter
Top Products
Getting Started
12
antenna wires, both 300 ohm
flat wire
300 ohm flat UHF and 75 ohm
round VHF
If you have "rabbit ears" (an antenna on top of your TV), you will need an
additional adapter and 75 ohm extension to make your leads reach from
the antenna to the VCR. This connection will work only if you have a
strong, clear picture on the TV, indicating a strong signal. Connect the
antenna to the adapter, and use the cable extension to go from the
adapter to the VCR. Use the supplied 75 ohm cable to connect the VCR
to the TV.
Now continue with the hookup:
1. Using whichever adapter you have fit your antenna with, attach that
connector to the IN FROM ANT jack on the back of the VCR.
2. Using the 75 ohm cable supplied with your VCR, connect either end to
the OUT TO TV jack on the back of the VCR.
3. Use a second adapter to attach the other end of the 75 ohm connector
back into the TV (where you first disconnected the antenna).
Capabilities: With this hookup, you should now be able to perform all basic
functions provided by this equipment.
5 Attach the TV and VCR to the Power Supply
Plug in the TV and VCR power cords to the wall outlet or an appropriate
extension cord or surge protector. See Important Safeguards for further
precautions (page 6).
6 Install Batteries in the Remote Control
The remote control requires two fresh "AA" batteries. On the back of the
remote, a plastic cover slides off in the direction shown by the arrow.
Remove this cover and install the batteries, matching the plus end of each
battery with the plus mark on the remote.