Filter
Top Products
Basic Operations (VCR Plus + Recording)
36
1. Press GUIDE, then press 1 to select VCR PLUS RECORDING and
bring up this screen:
2. Use the number buttons to enter the PlusCode of the program you want
to record. This code can be up to eight digits. If you enter a wrong digit,
press CLEAR and enter the correct one.
3. If you accidentally enter a nonexistent PlusCode, the VCR gives you an
error message that disappears from the screen in about 10 seconds.
4. If you have entered the correct PlusCode, press GUIDE to store the
PlusCode in the VCR's memory. This brings up another screen:
5. Press number buttons 1, 2, or 3 to select ONE TIME, DAILY, or
WEEKLY RECORDING.
Important: Programming does not take effect unless you select one of
these options.
6. When the next screen comes up, choose between standard or
extended tape speed by pressing the 5 button. This is also a good time to
check the channel number - it should be the one on which you usually
watch the program at home. (If not, you need to check your VCR Plus+
channel setup.)
7. Review the screen to be sure everything is set as you want, then press
GUIDE to complete your programming or continue with additional
programs.
When you have set up all the timed recordings you want:
Don't forget to load a videocassette (with the safety tab still attached) to
record on.
If using a cable box the VCR can control, turn on the cable box before
the time the recording is to begin.
If using a cable box the VCR cannot control, turn on the cable box and
tune it to the channel you want to record before the time the recording is to
begin.