Filter
Top Products
5
1. GENERAL INFORMATION
Remote control unit (RC-1135)
q
w
o
i
u
y
e
r
t
q
POWER button
Press this button to turn the power on or off.
w
SD/USB input select buttons
Press either of the buttons to select an input source.
e
2/; button
Press this button to start playback or pause playback.
r
9 button
Press this button to stop playback.
t
PITCH +/– buttons
Press this button to change the playback speed.
y
FOLDER +/– buttons
Press this button to skip a folder.
u
TRACK +/– buttons
Press this button to skip a track.
i
FF/REW button
• Press this button to accurately change the position
when playback will start.
• Hold the button pressed to start playback as FF or FR.
o
CUE button
Press this button to move to the playback start point.
•
BEFORE USING THE REMOTE CONTROL UNIT
A lithium battery comes installed in the remote control unit.
Before use, pull out the insulation sheet.
Insulation sheet
• BATTERY REPLACEMENT
If the battery of the remote control unit is exhausted, the
operable distance of the remote control unit becomes
extremely short. In such a case, replace the battery with
a new one.
1. Slide out the battery holder from the remote control by
pushing into the hole in the holder with a ball-point pen,
etc.
2. Pull out the old lithium battery from the battery case
and insert a new one. Place the battery so that the +
(positive) side faces upward.
3. Replace the battery case in its original position.
1
2
3
Battery
Battery case
a ball-point pen, etc.
•
OPERABLE RANGE OF THE REMOTE CONTROL UNIT
The operable range of the remote control unit is shown in
the figure below.
5m (16.4ft.)
Notes On Use
• Do not allow direct sunlight, an inverter fluorescent light
or other strong light to shine onto the unit’s infrared
signal reception window (remote sensor). Doing so may
disable operation of the remote controller.
• Note that operating the remote controller may cause
other devices operated by infrared rays to be operated
by mistake.
• The remote controller cannot be operated if the line
of sight between the remote controller and the unit’s
remote sensor is obstructed.
• Do not place any objects on top of the remote controller.
Doing so may cause one or more buttons to be held
down, which will cause the battery to run down.
• CAUTIONS ON HANDLING BATTERIES
Misuse of the lithium battery can result in heat buildup,
ignition, or rupture. Bear in mind the following points when
using or replacing batteries.
• The supplied battery is for testing the functionality of the
remote controller.
• Use a CR2025 lithium battery.
• NEVER recharge the battery.
• Do not handle the battery roughly or deconstruct the
battery.
• When replacing the battery, place it with correct polarity
(+ and -).
• Do not leave the battery in a place subject to high
temperature, such as a place subject to direct sunlight.
• Keep the battery in a place beyond infants’ or children’s
reach. If a battery is swallowed, consult a physician
immediately.
• If electrolyte has leaked, discard the battery immediately.
Be careful when handling such a battery, because if the
electrolyte is attached to your skin or clothes, you may
be burned. If it is accidentally attached, immediately
wash with tap water then consult a physician.
• When a battery which is no longer required is to be
discarded, insulate it with tape, etc. and dispose of
it in a place without fire, by following the directions
(regulations) laid down by the local authorities in the area
concerned for its disposal.