Filter
Top Products
2-13
User Guide for Cisco Digital Media Player Device Manager 1.1
OL-13985-01
Chapter 2 Using DMPDM
Selecting the Content to Show
Selecting the Content to Show
Note If you enter URLs for both video content and browser content, the actual result depends on a
combination of these factors:
• Whether you click or (to show only that one kind of content). See Using One-Click
Options for a DMP Display, page 2-1.
• What height and width values you enter for the embedded browser. See Adjusting Embedded
Browser Settings, page 2-4.
• What amount of transparency you assign to the HTML plane. See Adjusting the Transparency of the
HTML Content Plane, page 2-15
URLs cannot contain any more than 254 characters, cannot contain any spaces, and must use
ISO/IEC-8859
(Latin-1) character encoding.
Topics in this section explain how you can select the video or web-based content to show on your
DMP
display and how you can show both kinds of content simultaneously.
• Showing or Stopping Video Content from a UDP Multicast Stream, page 2-13
• Showing or Stopping Video Content from an HTTP URL, page 2-14
• Showing or Stopping Video Content from a File Stored on Your DMP, page 2-14
• Adjusting the Transparency of the HTML Content Plane, page 2-15
• Specifying the URL to Show on the HTML Content Plane, page 2-16
• Supported Fonts, page 2-17
Showing or Stopping Video Content from a UDP Multicast Stream
To show on your DMP display the video content from a UDP multicast stream, or to stop showing that
video content, do the following:
Step 1 In the Display Actions list, click Video Multicast.
Step 2 Enter or edit the required values, as described in Table 2-8.
Step 3 Do one of the following:
• To start showing the video content immediately, click Start.
• To stop showing the video content immediately, click Stop.