Filter
Top Products
35
DANSK
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKA
ESPAÑOL
PORTUGUÊS
The settings for these vehicle types
have already been programmed.
➮ Press the DEQ button ?.
➮ Press the or button 7 repeat-
edly until “CAR PRESETS” ap-
pears in the display.
➮ Press the OK button :.
➮ Repeatedly press the or button
7 until the vehicle type that you
want is displayed.
➮ Press the DEQ button ?.
The settings are saved.
Automatic equalizer calibration
(only Acapulco MP54)
You can electronically calibrate and
store values for three different situations,
e.g.:
EQ 1 for the driver only
EQ 2 for the driver and front passen-
ger
EQ 3 for the front and rear occupants
Hold the calibration microphone in the
appropriate position whilst calibration is
taking place.
The position of the calibration micro-
phone for Situation 1 (e.g. for the driver
alone) is at the height of the driver’s
head, approx. 10 cm next to the right
ear.
For Situation 2, the calibration micro-
phone should be positioned at head
height between the driver and the front
passenger.
For Situation 3, you should position the
calibration microphone at head height
in the centre of the vehicle interior (left/
right, front/rear).
Really quiet surroundings are required
for the calibration. Any extraneous noise
will distort the measured values.
The windows, doors and sunroof must
remain closed during the calibration
process. You should be seated in the
driving seat throughout this procedure.
Note:
You can obtain the calibration micro-
phone necessary for this from acces-
sory retailers.
During calibration, the temperature in-
side the vehicle must not exceed 55 °C
since this could lead to falsified meas-
urements.
The sound radiating from the loud-
speakers must not be obstructed by any
objects. All the loudspeakers must be
connected. The microphone must be
connected to the device.
To calibrate the automatic equalizer,
➮ press the DEQ button ?.
➮ Press the or button 7 repeat-
edly until “MANUAL EQ” appears in
the display.
➮ Press the OK button :.
➮ Press the or button 7 repeat-
edly until the equalizer that you
want to calibrate (“USER EQ1”,
“USER EQ2” or “USER EQ3”) ap-
pears in the display.
➮ Press the OK button : twice.
➮ Press the ESC button 8.
➮ Press the or button 7 repeat-
edly until “AUTO EQ” appears in
the display.
EQUALIZER