Printer Configuration and Adjustment
Adjust Printer Settings
72
P1066582-002 ZT400 Series™ User Guide 4/8/14
LCD Contrast Change the contrast on the printer’s display.
Accepted values:
3 to 15
Related ZPL command(s): none
SGD command used:
display.contrast
User menu item: LCD CONTRAST on page 97
Printer web page: N/A
Idle Display Select the information shown on the printer’s display when the printer is idle.
Accepted values:
• FW VERSION
• IP ADDRESS
• MM/DD/YY 24 HR
• M/DD/YY 12 HR
• DD/MM/YY 24 HR
• DD/MM/YY 12 HR
Related ZPL command(s): none
SGD command used:
device.idle_display_format
User menu item: IDLE DISPLAY on page 97
Printer web page: N/A
Power-Up Action Set the action for the printer to take during the power-up sequence.
• CALIBRATE adjusts sensor levels and thresholds, determines the label length, and
feeds the media to the next web.
• FEED—feeds the labels to the first registration point.
• LENGTH determines the label length using current sensor values, and feeds the
media to the next web.
• NO MOTION tells the printer not to move the media. You must manually ensure
that the web is positioned correctly, or press feed to position the next web.
• SHORT CAL sets the media and web thresholds without adjusting sensor gain,
determines the label length, and feeds the media to the next web.
Accepted values:
• CALIBRATE
• FEED
• LENGTH
• NO MOTION
• SHORT CAL
Related ZPL command(s):
^MF
SGD command used:
ezpl.power_up_action
User menu item: POWER UP ACTION on page 97
Printer web page: View and Modify Printer Settings > Calibration
Table 2 • Calibration and Diagnostic Tools (Continued)
