
1–3
SCANTEAM 3400PDF User’s Guide
Connecting the Scanner
Install the scanner by following the steps shown below:
➊ Turn off the power to the host system.
➋ Connect the interface cable to the scanner and to the terminal/computer.
Keyboard Wedge Interface Example
Disconnect
1
2
3
➌ Turn on the power to the host system.
➍ Program your scanner to work with yourterminal or computer byscanning
the Terminal Set-Up Codes. Either scan the Plug and Play codes (Page
1-7) or use the Supported Terminal list (Pages 1-9) to determine your
terminal's Terminal ID.
With Plug and Play programming, youconnect the scanner and scan onlyone
bar code and required prefixes and suffixes to program the scanner to work
with a designated interface.
➎ Todetermine if yourscanner is setup correctly, scan oneof the samplebar
codes on the back cover of this guide.
(Cable, Keyboard, and Terminal will vary.)