8 LonTalk Communication Interface • ACC-SVN100A-EN
Hardware Installation
Required Tools for Installation
The following tools are required for installing and setting up a LonTalk™
Communications Interface for Chillers with a Tracer AdaptiView™:
• Laptop computer with:
1
– Tracer™ TU software.
– Tracer UC800 controller software
Note: To download the most recent versions of Tracer TU software and UC800
software, go to the Tracer UC800 Software Download site: http://
www.trane.com/commercial/software/tracerUC800/.
– Rover™ Service Tool software—at minimum, Version 6.0. You can verify the
version currently being used by looking at the splash screen as Rover starts.
2, 3
• USB type A/B cable for the Tracer TU service tool.
• Rover LonTalk PCMCIA adapter, PN ADP01020 (refer to “Rover Service Tool Parts List,”
p. 59).
• Rover LonTalk adapter cable, PN CAB00283 (refer to “Rover Service Tool Parts List,”
p. 59).
• Screwdriver.
• Magnet- south pole.
1
This guide assumes you are familiar with using Rover and Tracer TU service tools. If not and additional information is needed,
refer to “Additional Resources,” p. 60.
2
Non-Trane LonTalk software tools can be used, instead of the Rover service tool, for the procedures in this guide. These
tools most likely require appropriate XIF and NXE files. Find the XIF file at www.lonmark.org in the product directory. Both
the NXE and the XIF files can be found in the directory of a computer that has the correct version of Rover installed:
C:\Program Files\Rover\Images. Contact your local Trane office to get these files. However, go to the vendor of that tool for
technical support, since Trane will not provide technical support for another vendor’s software tool.
3
For information about parts for the Rover service tool, refer to “Rover Service Tool Parts List,” p. 59.
