MSD 7R SHEARS
Page 4 Section 1 Introduction to Safety
NEVER remove any pins unless the attachment is on
the ground and blocked up or serious injury or death
could result. Metal chips or debris may fl y when a
connecting pin is struck. Use a brass drift when striking
pins and always wear protective clothing and proper eye
protection. Pins may fl y when struck with force to drive
them in or out. Keep people clear when removing or
installing pins.
NEVER operate equipment without the original
equipment safety guards in place. If the cab glass
is missing or damaged, check with your dealer or
manufacturer for proper replacement.
Under no circumstances should any modifi cations
be made to LaBounty equipment without factory
authorization.
ALWAYS lower the boom to the ground before
leaving the cab. If it is necessary to work on an
attachment off the ground, securely support the
machine and attachment. DO NOT support the
machine on cinder blocks, hollow tiles, or props that
may crumble under continuous load. DO NOT rely
on a cylinder to hold the attachment in the air. DO
NOT work under a machine that is supported only by
a jack.
DO NOT let hot hydraulic oil get in contact with the
skin as it could cause severe burns. Wear adequate
protective clothing and safety equipment. DO NOT
tamper with any hydraulic line or component while
it is pressurized. Escaping fl uid under pressure can
penetrate the skin, causing serious injury. Relieve
pressure before unhooking hydraulic or other lines.
Tighten all connections before applying pressure.
Keep hands
and body away from pinholes and nozzles
which eject fl uids under high pressure. Use a piece of
cardboard to search for leaks. If ANY fl uid is injected
into the skin, seek immediate medical assistance.
SAFETY SUMMARY continued
Before leaving the operator’s seat, you MUST do the
following:
1. Close the jaws of the shear.
2. Rotate the shear to a horizontal position.
3. Lower the lift arms fully.
4. Engage the brake.
5. Stop the engine.
6. Raise the seat bar.
7. Move the pedals until both pedals are locked.
DO NOT weld on any structural member unless
specifi cally authorized by LaBounty. Any unauthorized
welding or welding procedures will void the warranty,
and may cause structural failure or result in personal
injury.
ALWAYS wear close-fi tting clothing and safety
equipment appropriate to the job. Safety equipment
should be worn at all times when viewing, operating,
or maintaining the attachment to prevent injury.
Safety equipment includes eye protection, hard hat,
steel toe shoes, gloves, and hearing protection.
Keep clear of all potential pinch points, including
the moving upper jaw, cylinder connections, bucket
linkages or other moving parts.
Before operating the attachment, read and
observe all safety instructions in the Operation
and Maintenance sections of this manual. If you
are unfamiliar with any operation or maintenance
procedure, seek instruction before proceeding.
