Version Description
7.5.1.0 Introduced on the C-Series.
Usage
Information
To configure a list of possible domain names, configure the ip domain-list
command up to six times.
If you configure both the ip domain-name and ip domain-list commands,
the software tries to resolve the name using the ip domain-name command. If
the name is not resolved, the software goes through the list of names configured
with the ip domain-list command to find a match.
To enable dynamic resolution of hosts, use the following steps:
• specify a domain name server with the ip name-server command
• enable DNS with the ip domain-lookup command
To view current bindings, use the show hosts command. To view a DNS-related
configuration, use the
show running-config resolve command.
Related
Commands
ip domain-name — specifies a DNS server.
ip domain-lookup
To address resolution (that is, DNS), enable dynamic host-name.
Z9500
Syntax
ip domain-lookup
To disable DNS lookup, use the no ip domain-lookup command.
Defaults Disabled.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
944
IPv4 Routing
