Version Description
9.5(0.1) Introduced on the Z9500.
Usage
Information
If your Z9500 switch has a 36 40G-port license, all 40G ports (144 10G ports) on
line card 0 are enabled and usable. You can purchase a license to use additional
ports:
• 84 40G ports on line cards 0 and 1 (336 10G ports)
• 132 40G ports on line cards 0, 1, and 2 (528 10G ports)
You can upgrade from a 36 40G-port to either an 84 40G-port or 132 40G-port
license. You can upgrade from an 84 40G-port to a 132 40G-port license.
In the install license command syntax, host-ip is either an IPv4 dotted
decimal address or an IPv6 [x:x:x:x::x] format address.
An error message is displayed if the license is corrupted or invalid.
Enter Yes at the prompt to continue the installation.
You must reload the switch to enable the licensed ports.
Example
Dell# install license tftp://10.11.8.12/132.lic
!
3594 bytes successfully copied
Retrieving license ....... (OK)
LICENSE INFORMATION
Vendor : Dell
Product : Dell Force10 Z9500
System Service Tag : RtHvKsJ
License Service Tag : RTHVKSJ
Feature : HW-Port-License 132 Ports
Retrieving license data ....... (OK)
Validating license ....... (OK)
Validating Service Tag in license ....... (OK)
Note: You must reload the chassis to activate the license.
System will continue to run with current active 84 ports
until the next reload !
Continue to install license [yes/no]: yes
Installing license ....... (ok)
License installation successful. Restart chassis to activate
license
Dell#Jul 1 11:00:58: %SYSTEM:CP %LICMGR-5-
LICMGR_LIC_INSTALL_SUCCESS: License file install is successful
1370
Pay As You Grow
