ipv6 pim sparse-mode
Enable IPv6 PIM sparse mode on the interface.
Syntax
ipv6 pim sparse-mode
To disable IPv6 PIM sparse mode, use the no ipv6 pim sparse-mode
command.
Defaults Disabled.
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
7.4.1.0 Introduced on the S6000.
Usage
Information
Enable the interface (use the no shutdown command) and not have the
switchport command configured. Also enable Multicast globally. PIM is
supported on the port-channel interface.
ipv6 pim spt-threshold
Specifies when a PIM leaf router should join the shortest path tree.
Syntax
ipv6 pim spt-threshold {kbps | infinity}
To return to the default value, use the no ipv6 pim spt-threshold command.
Parameters
kbps Enter a traffic rate in kilobytes per second. The range is from
0 to 4294967 kbps. The default is 10 kbps.
infinity Enter the keyword infinity to have all sources for the
specified group use the shared tree and never join shortest
path tree (SPT).
Defaults 10 kbps
1412
PIM-Sparse Mode (PIM-SM)
