To delete a peer group, use the no neighbor peer-group-name peer-group
command.
Parameters
peer-group-
name
Enter a text string up to 16 characters long as the name of
the peer group.
Defaults Not configured.
Command
Modes
ROUTER BGP
Command
History
Version Description
9.2(1.0) Introduced on the Z9500.
8.2.1.0 Introduced on the E-Series ExaScale.
7.4.1.0 Introduced
Usage
Information
When a peer group is created, it is disabled (shut mode).
Related
Commands
• neighbor peer-group (assigning peers) – assigns routers to a peer group.
• neighbor remote-as – assigns an indirectly connected AS to a neighbor or peer
group.
• neighbor shutdown – disables a peer or peer group.
neighbor peer-group passive
Enable passive peering on a BGP peer group, that is, the peer group does not send an OPEN message,
but responds to one.
Z9500
Syntax
neighbor peer-group-name peer-group passive
To delete a passive peer-group, use the no neighbor peer-group-name
peer-group passive command.
Parameters
peer-group-
name
Enter a text string up to 16 characters long as the name of
the peer group.
Defaults Not configured.
Command
Modes
ROUTER BGP
Command
History
Version Description
9.2(1.0) Introduced on the Z9500.
Border Gateway Protocol
547
