lii
Software Configuration Guide—Release 15.0(2)SG
OL-23818-01
Preface
Chapter 9 Configuring Cisco NSF with SSO
Supervisor Engine Redundancy
Describes how to configure supervisor engine
redundancy using Cisco nonstop forwarding (NSF)
with stateful switchover (SSO).
Chapter 10 Environmental Monitoring and
Power Management
Describes how to configure power management and
environmental monitoring features.
Chapter 11 Configuring Power over Ethernet Describes how to configure Power over Ethernet
(PoE).
Chapter 12 Configuring the Catalyst 4500
Series Switch with Cisco Network
Assistant
Describes how to install and configure Network
Assistant and Embedded CiscoView.
Chapter 13 Configuring VLANs, VTP,
and VMPS
Describes how to configure VLANs, VTP, and
VMPS.
Chapter 14 Configuring IP Unnumbered
Interface
Describes how to configure IP Unnumbered
support.
Chapter 15 Configuring Layer 2 Ethernet
Interfaces
Describes how to configure interfaces to support
Layer 2 features, including VLAN trunks.
Chapter 16 Configuring SmartPort Macros Describes how to configure SmartPort macros.
Chapter 17 Configuring Auto SmartPort
Macros
Describes how to configure Auto SmartPort Macros
Chapter 18 Configuring STP and MST Describes how to configure the Spanning Tree
Protocol (STP) and the Multiple Spanning Tree
(MST) protocol and explains how they work.
Chapter 19 Configuring Flex Links and MAC
Address-Table Move Update
Describes how to how to configure Flex Links on a
switch.
Chapter 20 Configuring Resilient Ethernet
Protocol
Describes how to configure Resilient Ethernet
Protocol (REP).
Chapter 21 Configuring Optional STP
Features
Describes how to configure the spanning-tree
PortFast, UplinkFast, BackboneFast, and other STP
features
Chapter 22 Configuring EtherChannel and
Link State Tracking
Describes how to configure Layer 2 and Layer 3
EtherChannel port bundles.
Chapter 23 Configuring IGMP Snooping and
Filtering
Describes how to configure Internet Group
Management Protocol (IGMP) snooping.
Chapter 24 Configuring IPv6 MLD Snooping Describes how to configure IPv6 MLD Snooping.
Chapter 25 Configuring 802.1Q Tunneling,
VLAN Mapping, and Layer 2
Protocol Tunneling
Describes how to configure 802.1Q and Layer 2
protocol Tunneling.
Chapter 26 Configuring CDP Describes how to configure the Cisco Discovery
Protocol (CDP).
Chapter 27 Configuring LLDP, LLDP-MED,
and Location Service
Describes how to configure Link Layer Discovery
Protocol (LLDP).
Chapter 28 Configuring UDLD Describes how to configure the UniDirectional Link
Detection (UDLD) protocol.
Chapter Title Description
