12-3
Software Configuration Guide—Release 15.0(2)SG
OL-23818-01
Chapter 12 Configuring the Catalyst 4500 Series Switch with Cisco Network Assistant
Network Assistant-Related Parameters and Their Defaults
Network Assistant-Related Parameters and Their Defaults
Table 12-1 lists the Network Assistant-related configuration parameters on a Catalyst 4500 series
switch.
Network Assistant CLI Commands
Table 12-2 describes the Network Assistant-related CLI commands.
Table 12-1 Network Assistant-Related Configuration on a Catalyst 4500 Series Switch
Parameters Default Value Recommended Value
Authentication Disabled Optional
IP address Depends on
community or
discovery option
1
1. You need to set an IP address in each switch for community device discovery and for the cluster
commander.
User selectable
IP HTTP port number 80 Optional
2
2. Port number on the Network Assistant and the Catalyst 4500 series switch must match.
IP HTTPS port number 443 Optional
3
3. You can only change this value for a cluster of devices. Port number on the Network Assistant and on the
Catalyst 4500 series switch must match. Value can be changed to any non-default number above 1024.
IP HTTP server Disabled Enabled
4
4. Required for Network Assistant to access the device.
Cluster run Disabled Enabled
5
5. Enabled only if you want to manage a cluster of devices.
Table 12-2 CLI Commands
Command Functions
[no] cluster enable
Names the cluster.
[no] cluster run
Enables clustering.
Note This command is used strictly for
clustering.
[no] ip http server
Configures the HTTP on a switch.
[no] ip http port port_number
Configures the HTTP port.
[no] ip domain-name domain_name
Configures the domain on the switch.
[no] ip http secure-server
Configures and enable HTTPS on a switch.
[no] ip http secure-port
port_number
Configures the HTTPS port.
[no] ip http max-connections
connection_number
Configures the maximum concurrent
connections to the HTTP server.
