Operational, Basic, and Advanced Parameters
41-001343-02 REV04 – 05.2014 A-122
No Service Congestion Tone Settings
Status Code on Ignoring Incoming Calls
Switch Focus to Ringing Line
Parameter –
no service congestion tone
Configuration Files
aastra.cfg, <model>.cfg, <mac>.cfg
Description If enabled, the congestion tone will replace the conventional dial tone when the handset
is off hook, a headset is employed, or the speakerphone is engaged. The congestion tone
is played on a per line basis whereby only the specific lines that are without service are
affected.
Format Boolean
Default Value 0 (disabled)
Range 0-1
0 (disabled)
1 (enabled)
Example no service congestion tone: 1
Parameter –
sip ignore status code
Configuration Files
aastra.cfg, <model>.cfg, <mac>.cfg
Description Specifies the status code that is sent in the response to the server when a user ignores
an incoming call.
Format Integer
Default Value 486
Range Valid SIP final negative response code (Refer to RFC3261)
Example sip ignore status code: 486
Parameter –
switch focus to ringing line
Configuration Files
aastra.cfg, <model>.cfg, <mac>.cfg
Description Specifies whether or not the UI focus is switched to a ringing line while the phone is in
the connected state.
Format Boolean
Default Value 1 (enable)
Range 0 (disable)
1 (enable)
Example switch focus to ringing line: 1
