Network Settings
41-001343-02 REV04 – 05.2014 4-43
The following table shows the DSCP range/VLAN priority mapping:
The following table identifies the default DSCP values for the protocols:
Configuring Type of Service (ToS)/DSCP (optional)
Use the following procedures to configure ToS/DSCP on the IP phone.
DSCP Range VLAN Priority
0-7 0
8-15 1
16-23 2
24-31 3
32-39 4
40-47 5
48-55 6
56-63 7
Protocol Name Default DSCP Values in the ToS Field
sip 26
rtp 46
rtcp 46
Note:
ToS/DSCP is enabled by default. The SIP, RTP, and RTCP parameters show defaults of 26, 46, and 46, respectively. Use the
following procedures to change these settings if required.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section, “Type of Service (ToS)/DSCP Settings” on pageA-39.
IP Phone UI
1.
Press on the phone to enter the Options List.
2. Select Administrator Menu.
3. Enter your Administrator password.
Note:
The IP Phones accept numeric passwords only.
4. Select Network Settings.
5. Select Type of Service DSCP.
6. Select Type of Service SIP.
or
Select Type of Service RTP.
or
Select Type of Service RTCP.
