Sony NW-MS70D MP3 Player User Manual


 
21
Basic Operations
4Attach the Network Walkman to the recording USB cradle.
Note
Be sure to attach your Network Walkman in the direction of the arrow as illustrated below.
3 Start recording.
When synchro-recording is cancelled
1Pause the playback of the CD, etc., that you want to record.
2Press the REC/PAUSE button on the recording USB cradle.
The recording LED on the recording USB cradle lights up, and recording starts. The REC icon is displayed on the
left side of the display, followed by the track name*, displayed to the right. The remaining recordable time will
then be displayed (Remaining counter).
3Start playback of the CD, etc.
When synchro-recording is activated
1Press the REC/PAUSE button on the recording USB cradle.
The recording LED on the recording USB cradle flashes, and recording enters standby mode. The REC icon, the
icon which indicates synchro-recording, and the recording bit rate and remaining recordable time flash.
2Start playback of the CD, etc.
After playback starts, the recording LED on the recording USB cradle lights up, and recording starts. In the
display, after the track name* is displayed, the remaining recordable time will be displayed (Remaining counter).
* The track name is displayed as “GxxxTxxx” (the group number and the track name).
To cancel recording
Press the STOP button on the recording cradle.
To pause recording
Press the REC/PAUSE button on the recording USB cradle. The recording LED flashes while paused. Press the
REC/PAUSE button again to continue recording.
z Tip
To activate/cancel synchro-recording, refer to “Changing the setting of synchro-recording” on page 38.
Notes
Synchro-recording is available only when recording from a digital audio device using an optical digital cable.
If you pause recording, the remaining part of the current track from that point will be recorded as a new track, and
the track number will be renewed.
USB cradle
connector
Recording
USB cradle