Filter
Top Products
To remove the player from the USB cradle
Press RELEASE.
RELEASE
Notes
• If the player is connected to the computer for
a long time while charging, charging may stop
to prevent the temperature of the player from
increasing too much. In this case, the CHG lamp
goes out. Remove the player from the USB cradle
and start charging again after a while.
• If the player will not be used for three months or
more, set the BUILT-IN BATTERY switch to OFF
to prevent degradation of the battery.
• Charge the battery in an ambient temperature of
between 5 to 35ºC (41 to 95ºF).
Notes on the AC power adaptor
• Use only the AC power adaptor and USB
cradle supplied with the player. Do not use
any other AC power adaptor since this may
cause the player to malfunction.
• The player is not disconnected from the
AC power source (mains) as long as it is
connected to the wall outlet, even if the
player itself has been turned off.
• If you are not going to use the player for a
long time, be sure to disconnect the power
supply. To remove the AC power adaptor
from the wall outlet, grasp the adaptor plug
itself; never pull the cord.
Checking the remaining
power of the battery
The remaining power of the battery is
indicated in the display. As the black indicator
section decreases, the remaining power is
depleted further.
*
* “LOW BATTERY” appears in the display and
beep sounds.
When the battery is depleted, recharge the
battery.
Notes
• The display shows the approximate battery power
remaining. For example, one section does not
always indicate one-fourth of the battery power.
• Depending on the operating conditions, the display
may increase or decrease relative to the actual
power remaining.
Battery life (continuous use)
Playing time for ATRAC3plus 48 kbps is
approximately 30 hours.
The amount varies depending on how the
player is used.
9
Getting Started