Filter
Top Products
33
B
Connecting to a power source
You can check the remaining power of the
batteries in the display.
t t t t t
Lobatt*
* Beep sounds.
When the batteries are depleted, charge the
rechargeable batteries or replace the dry
batteries with new ones.
• Using the rechargeable batteries (this page)
• Using the dry batteries (external battery
case) (page 35)
Notes
• The indicator sections of roughly show the
remaining battery power. One section does not
always indicate one-fourth of the battery power.
• Depending on operating conditions, the indicator
sections of
may increase or decrease.
• When using the rechargeable batteries and dry
batteries together to extend power, use a fully
charged rechargeable batteries and new dry
batteries.
For the battery life and charging time of the
rechargeable batteries, see “Specifications.”
Using the rechargeable
batteries
Charge the rechargeable batteries
before using them for the first time.
To keep the original battery capacity
for a long time, charge the batteries
only when it is completely depleted.
You can use only the following
rechargeable batteries for your CD
player.
• NH-10WM (supplied)
• NH-14WM (not supplied)
1
Slide OPEN to open the lid of your
CD player, then open the battery
compartment lid inside the player.
2
Insert rechargeable batteries by
matching the 3 to the diagram in
the battery compartment and
close the lid until it clicks into
place.
Insert the # end first
(for both batteries).
Connecting to a power source
(Continued)