Filter
Top Products
46
When disposing the
Network Walkman
This Network Walkman has a built-in nickel metal
hydride battery. When you dispose of the Network
Walkman, be sure to dispose of it properly.
Certain countries may regulate disposal of the battery
used to power this product.
Consult with your local authority.
Note
Never disassemble your Network Walkman except when
disposing of it.
To remove the Nickel Metal Hydride
battery
1 Remove the screws (A and B) at the sides
using a Phillips screwdriver.
2 Remove the cover.
3 Disconnect the connector and then remove the
battery.
4 Insulate the connector terminal by wrapping
with a tape.
Precautions (continued)
Nickel Metal Hydride battery
A
B
On handling the “Memory Stick Duo”
AB
C
• Do not label “Memory Stick Duo” to prevent
sticking it in the slot.
• You cannot record, edit, or delete data stored in
a “Memory Stick” when the erasure prevention
switch is set to “LOCK.” (A)
• Use a tapered tool when you set the erasure
prevention switch.
• Do not remove “Memory Stick” while reading
or writing data.
• Do not perform the following to prevent damage
to data.
– Remove “Memory Stick” or turn off your
Network Walkman while reading or writing
data.
– Operate your Network Walkman in the
location under the influence of static charge or
electrical noise.
• Making a backup of important data is
recommended.
• Do not apply too much pressure to “Memory
Stick” when you write down in the memo area.
(C)
• Keep a “Memory Stick” in its supplied case
when you carry or store it.
• Do not touch the “Memory Stick” connector
with your finger or metallic objects. (B)
• Do not bend, drop, or subject a “Memory Stick”
to strong shock.
• Do not disassemble or modify a “Memory
Stick”.
• Do not allow a “Memory Stick” to get wet.
• Do not use or store your Network Walkman in a
location that is subjected to:
– Extremely high temperature such as in a sun-
heated car
– Direct sunlight
– High humidity or places with corrosive
substances