Filter
Top Products
3.Press Tuning UP and DOWN button at the same time for more than 2 seconds.
The radio will beep and then scan from the lowest frequency on the selected
band. Automatically storing stations in preset memory based on signal strength.
4.After APS is completed, a beep will be heard. The display will show M1 and the
strongest station for your area.
5.If during APS operation, no stations are found, display will show lowest frequency
of selected band.
Note:
1.The maximum number of preset is 9 each on FM/MW/LW bands. If during APS
operation more than 9 presets are found, there will be only 9 stations stored in
the preset memories.
2.The SW band has no APS function.
3.All previous stored preset stations will be erased when APS operation
commences.
4.APS operation can be cancelled by pressing the POWER on/off
This radio provides a feature called Memory Scan, when activated will scan the
Preset memories.
1.Turn on the radio by pressing the POWEN button. Select the required waveband.
2.Press the M.SCAN button, the radio will scan each preset memory in turn-pause
for 7 seconds on each memory before continuing on to the next memory. When
the required preset is reached, press any button to stop memory scan.
The alarm can beset with the radio power on or off.
If the radio is switched on, press DISPLAY button display the time.
1.Press RADIO ALARM button , display radio alarm icon will flash and show
the last alarm time set. Press the number buttons then ENTER to set RADIO
alarm time.
2.To verify the alarm time, Press RADIO ALARM button to display the alarm time
followed by ENTER button to return to real time mode.
3.To cancel radio alarm set, press RADIO ALARM button, display will show
previous alarm set status then press C (Cancel) to cancel radio alarm set.
Display alarm icon will disappear.
Memory Scan
Setting the alarm (standby)
Setting Radio Alarm
8