Filter
Top Products
10
Numbered key 8 key 1 key
1 FM 100kHz FM 200 kHz
tuning step tuning step
2. MW 9 kHz MW 10 kHz
3 12 hour format 24 hour format
4 Beep tone off Beep tone on
5 Memory
Rearranged
Complete with ENTER button
For example, if you like to change from MW 10 kHz to 9 kHz, press MODE,
numbered button 2 , 0 , then complete with ENTER button.
You can rearrange your memory stations from low frequency to high frequency by
Pressing MODE, numbered button 5, 0 or 5, 1 then complete with(ENTER) button.
Some SW and LW stations transmit in Morse Code using a form of transmission
Called continuous wave (CW). Some SW stations use a special type voice
transmission called single side band (SSB).
To tune to a CW or SSB station, select the band and frequency and adjust the
antenna. In addition, switch the SSB switch to SSB position, Tuning/SSB LED will
be on Red. Then beginning at its midpoint, slowly adjust the CLARIFY dial until
reception becomes clear. You may at the same time use the rotary FINE tuning for
best SSB reception.
When a station is found, the Tuning/SSB LED will become in orange
CLARIFY tuning range can be + 1.5kHz
SSB (single side band)/Clarify(+,-)