Filter
Top Products
6
Note:
Each press of Up or Down button will change the frequency in increment of
FM: 100kHz or 200kHz depending on the versions.
MW: 9kHz or 10kHz depending on the versions.
SW: 5kHz
LW: 9kHz
Rotary tuning is accomplished using the convenient Rotary Tuning Knob. Original
tuning step is as below but can be changed by the MODE button as described later.
BAND FM MW LW SW
Step 100 or 200 kHz 9kHz or 10 kHz 9 kHz 5 kHz
Fine Tune 50 kHz 1 kHz 1 kHz 1 kHz
Note:
Fine tune can be op erated by pressing the rotary tuning knob in. Display will show
fine tune step then the last frequency tuned.
Note:
During fine tune operation, any press to other functional buttons will cause Fine
Tune back to normal tune.
1.Turn on the radio by pressing the POWER on/off button.
2.Select a waveband.
3.Press and hold down either the tuning UP or DOWN button for more than half a
second to commence scan tuning. The radio will scan all frequencies in the
selected band and stop automatically each time it finds an active station.
4.Press and hold down either the tuning UP or DOWN buttons for more than half a
second to resume scan tuning. When the waveband end is reached, the radio will
beep and continue tuning from the opposite waveband end.
5.Adjust the volume control for comfortable listening.
You may store up to 45 preset stations in memory. 18 on SW in 2 pages, 9 each on
FM, MW and LW bands. To store a station in preset memory, proceed as follows.
1.Turn on the radio by pressing the POWER on/off button.
2.Tune to the desired frequency using one of the previous described tuning
methods.
Manual tuning by Rotary tuning knob
Scan tuning
Memory tuning