Filter
Top Products
5
Waveband selection
Direct tuning
Manual tuning by tuning UP/DOWN button
There are four waveband selection by pressing BAND button
Waveband Frequency coverage Aerial Type
--------------------------------------------------------------------------------------------
FM 87.50- 108 MHz Telescopic
Full extend the aerial, angle
and rotate for best reception.
MW 520- 1710 kHz Internal
SW 1711- 29999 kHz Telescopic
Fully extend the aerial for
best reception.
LW 153- 279kHz Internal
Stations may be selected by using any of the five different available tuning methods:
Direct Tuning, Manual tuning, Scan tuning, Memory Recall Tuning and APS on MW.
FM and LW bands.
Example : To tune to 100.70 MHz on the FM band.
1.Press the POWER on/off button to turn on the radio.
2.Select the required FM band by pressing BAND button.
3.Press ENTER - Freq./time Set button, display shows "
4.Press the numbered buttons marked1,0,07., then press ENTER button again,
the frequency will now appear in the display.
Note:
There is no decimal point, therefore you press the number button, make sure
you have selected the required waveband, otherwise the operation may switch to
other waveband.
5.Extend the aerial fully and rotate for best FM reception.
6.Adjust the volume control for comfortable listening.
7.When selecting a stereo FM station and using stereo earphones, make sure the
FM mode switch is in the stereo position.
1.Press the POWER on/off button to turn on the radio.
2. Select a waveband by pressing BAND button.
3.A single press on either Tuning UP or Down button will change the frequency up
or down.