Filter
Top Products
If the video source is connected to all HDMI input, 14, 35
you must assign that input to all input selector, and
your TV must be connected to the HDMI OUT.
N Can't control other components
[f it's all Onkyo component, make sure that the f"41
cable and analog audio cable are connected properly.
Connecting only an f"41 cable won't work.
16
N There's no picture from a source connected to
an HDMI IN
Reliable operation with an HDMI-to-DVI adapter is 57
not guaranteed. In addition, video signals from a PC
are not guaranteed.
N The on-screen menus don't appear
On your TV, make sure that the video input to which --
the AV receiver is connected is selected.
If you' ve connected a cassette tape deck, to the
TWCD IN jack, or an RI Dock to the TWCD IN or
GAME IN or VCR/DVR INjacks, for the remote
controller to work properly, you must set the display.
To control an Onkyo component that's connected
via f"41, point the remote controller at the AV
receiver. Be sure to enter the appropriate remote
control code first.
32
47
r_
N Reception is noisy, FM stereo reception is
noisy, or the FM STEREO indicator doesn't light
Relocate your antenna.
Listen to the station in mono.
Passing cars and airplanes can cause interference.
22
N Can't record
On your recorder, make stare the correct input is
selected.
[I/.'/:11./_'_t'4_:,/_],'5"_.'iIf nothing improves the reception, install an outdoor --
antenna.
f_/':_?ST_[o/';TmI_IFJ'4
N The remote controller doesn't work
Before operating this unit, be stare to press
RECEIVER.
N Can't access the music files on a USB device
Make sure the USB device is plugged in properly. --
Install new batteries. Don't mix different types of 4
batteries, or old and new batteries.
[oJh'FOl_
Make stare that the AV receiver is not subjected to
direct sunshine or inverter-type fluorescent lights.
Relocate if necessary.
Make stare you've selected the correct remote
controller anode.
Make stare to set the same ID on both the AV
receiver and remote controller.
10, 48
41
USB memory devices with security functions cannot 21
be played.
N Standby power consumption
[n the following cases, the power consumption may 42
reach up to a maximum of 37 W:
- "HDMI Ctrl (RIHD)" setting is set to "On".
(Depending on the TV status, the AV receiver
will enter Standby mode as usual.)
- The "HDMI Through" setting is set to other than
"Off".
N The sound changes when I connect my
headphones
When a pair of headphones is connected, the
listening mode is set to Stereo, unless it's already set
to Stereo, Mono, or Direct.
Ell
52