Filter
Top Products
Error Messages
While Audyssey 2EQ® Room Correction and Speaker
Setup is in progress, one of the error messages below may
appear.
q
f'_;,;_,;;;,i'_;ig;;i;'o'_,i_;'i@ -- Error message
Cancel
The options are:
Retry:
Try again.
Cancel:
Cancel Audyssey 2EQ Room Correction and
Speaker Setup.
• Ambient noise is too high.
The background noise is too loud. Remove the source of
the noise and try again.
• Speaker matching error!
The number of speakers detected was different from
that of the first measurement. Check the speaker
connection.
• Writing Error!
This message appears if saving fails. Try saving again.
If this message appears after 2 or 3 attempts, contact
your Onkyo dealer.
• Speaker Detect Error
This message appears if a speaker is not detected. "No"
means that no speaker was detected.
Using a Powered Subwoofer
If you're using a powered subwoofer and it outputs very
low-frequency sound at a low volume level, it may not be
detected by Audyssey 2EQ Room Correction and Speaker
Setup.
If the "Subwoofer" appears on the "Review Speaker
Configuration" screen as "No", increase the subwoofer' s
volume to the half-way point, set it to its highest crossover
frequency, and then try running Audyssey 2EQ Room
Correction and Speaker Setup again. Note that if the
volume is set too high and the sound distorts, detection
issues may occur, so use an appropriate volume level. If
the subwoofer has a low-pass filter switch, set it to Off or
Direct. Refer to your subwoofer's instruction manual for
details.
• See "Speaker Configuration" for appropriate settings
(÷ page 12).
Changing the Speaker Setup Manually
You can manually make changes to the settings found
during Audyssey 2EQ Room Correction and Speaker
Setup.
See also:
• "Sp Config (Speaker Configuration)" (_ page 36)
• "Sp Distance (Speaker Distance)" (_ page 37)
• "Level Cal (Level Calibration)" (_ page 37)
ED
26