Filter
Top Products
m LipSync
Off
On
This function allows the AV receiver to automatically
correct any delay between the video and the audio, based
on the data from the connected monitor.
• This function works only if your HDMl-compatible TV supports
HDM[ Lip Sync.
After changing the settings of the "HDMI Ctrl
(RIHD)", "HDMI Through" or "Audio Return Ch",
turn off the power to all connected pieces of equipment
and then turn them on again. Refer to the instructions
for all connected pieces of equipment.
You can change various audio settings from the Home
menu (_ page 31).
1 Press RECEIVER followed by HOME.
2 Use &/, and ENTER to select "Audio", and then
use l/¥/_/_ to make the desired selection.
!
• These settings are not available ill either of the following cases:
- a pair of headphones is connected.
- the "Audio TV Out" setting is set to "On" (_ page 42) and
all input selector other than HDM[ is selected.
- "HDMI Ctrl (RIHD)" is set to "On" (_ page 42) and
you're listening through your TV speakers.
Tone Control Settings
I Bass
-10 dB to 0 dB to +10 dB in 2 dB steps
You can boost or cut low-frequency sounds output
from the front speakers.
m Treble
-10 dB to 0 dB to +10 dB in 2 dB steps
You can boost or cut high-frequency sounds output
from the front speakers.
You can adjust the bass and treble for the front speakers,
except when the Direct listening mode is selected.
Operating on the AV receiver
1 Press TONE on the AV receiver repeatedly to
select either "Bass" or "Treble".
2 Use + and - on the AV receiver to adjust.
Speaker Levels
m Subwoofer Level*l
-15 dB to 0 dB to +12 dB in 1 dB steps
m Center Level
-12 dB to 0 dB to +12 dB in 1 dB steps
You can adjust the volume of each speaker while listening
to an input source.
These temporary adjustments are cancelled when the AV
receiver is set to Standby. To save the setting you made
here, go to "Level Cal (Level Calibration)" (_ page 37)
before setting the AV receiver to Standby.
• You cannot use this function while the AV receiver is muted.
• Speakers that are set to "No" or "None" in the "Sp Config
(Speaker Configuration)" (_ page 36) cannot be adjusted.
"1 This procedure can also be performed on the AV receiver by
using its SUBWOOFER LEVEL.
Audyssey
m Audyssey
See "Audyssey" of "Source Setup" (_ page 39).
m Dynamic EQ
See "Dynamic EQ" of"Source Setup" (_ page 39).
m Dynamic Volume
See "Dynamic Volume" of "Source Setup" (_ page 39).
• These technologies can be used when all the following
conditions are met:
- Room Correction and Speaker Setup is completed. Note that
"Audyssey" requires the "Audyssey 2EQ Full Calibration"
method.
- Any listening mode other than Direct is selected.
- A pair of headphones is not connected.
- The input selector other than USB is selected.
• The setting is stored individually for each input selector.
• To bypass the bass and treble tone circuits, select the Direct
listening mode.
Ell
43