Filter
Top Products
Troubleshooting
If you have any trouble using the AV receiver, look for a
solution in this section. If you can't resolve the issue
yourself, contact your Onkyo dealer.
If you can't resolve the issue yourself, try resetting the
AV receiver before contacting your Onkyo dealer.
To reset tile AV receiver to its factory defaults, turn
it on and, while holding down VCR/DVR, press
ON/STANDBY."Clear" will appear on the display
and the AV receiver will enter Standby mode.
VOR/DVR
Note that resetting the AV receiver will delete your
radio presets and custom settings.
} Remote indicator
RECEIVER
i HOME
To reset the remote controller to its factory defaults,
while holding down RECEIVER, press and hold down
HOME until the remote indicator lights (about 3
seconds). Within 30 seconds, press RECEIVER
again.
N When the power is restored after a power
interruption, "CHECK SP WIRE" appears on the
display
The protection circuitry has been activated.
Remove the power cord fl'om the wall outlet
immediately. Disconnect all speaker cables and
input sources, and then leave the AV receiver with
its power cord disconnected for 1 hour. After that,
reconnect the power cord and set the volume to
maximum. [f the AV receiver stays on, set then the
volume to minimum, disconnect the power cord, and
reconnect your speakers and input sources. If the AV
receiver turns off when you set the volume to
maximum, disconnect the power cord, and contact
your Onkyo dealer.
N There's no sound, or it's very quiet
Make sure that the digital input source is selected 35
properly.
Make sure that the inputs and outputs of all
components are connected properly.
14-16
Make sure that the input source is properly selected. 19
Check the volume. The AV receiver is designed for 19
home theater enjoyment. It has a wide volume range,
allowing precise adjustment.
While a pair of headphones is connected to the
PHONES jack, no sound is output from the
speakers.
33
Check the digital audio output setting on the
connected device. On some game consoles, such as
those that support DVD, the default setting is off.
N Can't turn on the AV receiver
Make sure that the power cord is properly plugged
into the wall outlet.
N The AV receiver turns off unexpectedly
When the set Auto Standby starts running, the AV 41
receiver will automatically go standby.
If your turntable uses an MC cartridge, you must
connect an MC head amp, or an MC transformer.
Not all listening modes use all speakers.
Make sure that the speaker setup microphone is not
still connected.
15
27
EB
50