Filter
Top Products
This setting is set automatically by Audyssey 2EQ0¢
I
Room Correction and Speaker Setup (3 page 24).
1
Here you can specify the distance from each speaker to the
listening position so that the sound from each speaker
arrives at the listener's ears as the sound designer
intended.
N Unit
feet:
Distances can be set in feet. Range: lft to 30ft in
1 foot steps.
meters:
Distances can be set in meters. Range: 0.3m to 9.0m
in 0.3 meter steps.
(The default setting varies from country to country.)
N Left, Front High Left, Center, Front High Right,
Right, Surround Right, Surr Back Right, Surr
Back Left, Surround Left, Subwoofer
Specify the distance from the each speaker to your
listening position.
• These settings are not available in either of the following cases:
- a pair of headphones is connected.
- the "Audio TV Out" setting is set to "On" (_ page 42).
-"HDMI Ctrl (RIHD)" is set to "On" (_ page 42) and
you're listening through your TV speakers.
• Speakers that you set to "No" or "None" in the "Sp Coufig
(Speaker Configuration)" (_ page 36) cannot be selected.
"1 For the center speaker and subwoofer, the level settings made
by using HOME are saved here as the default settings.
• If you're using a haudheld sound level meter, adjust the level of
each speaker so that it reads 75 dB SPL at the listening position,
measured with C-weighting and slow' reading.
With the Audio Adjust functions and settings, you can
adjust the sound and listening modes as you like.
Multiplex/Mono Settings
N Multiplex
Input Ch (Mux)
Main
Sub
Main/Sub
This setting determines which channel of a stereo
multiplex source is output. Use it to select audio channels
or languages with multiplex sources, multilingual TV
broadcasts, and so on.
N Mono
Input Ch (Mono)
Left + Right
Left
Right
This setting specifies the channel to be used for playing
any 2-channel digital source such as Dolby Digital. or 2-
channel analog/PCM source in the Mono listening mode.
This setting is set automatically by Audyssey 2EQRoom Correction and Speaker Setup (3 page 24).
1
Here you can adjust the level of each speaker with the
built-in test tone so that the volume of each speaker is the
same at the listening position.
N Left, Front High Left, Center*l, Front High Right,
Right, Surround Right, Surr Back Right, Surr
Back Left, Surround Left
-12 dB to 0 dB to +12 dB in 1 dB step.
N Subwoofer*l
-15 dB to 0 dB to +12 dB in 1 dB step.
!
• These settings cannot be calibrated in either of the following
cases:
- a pair of headphoues is connected.
- the "Audio TV Out" setting is set to "On" (_ page 42).
-"HDMI Ctrl (RIHD)" is set to "On" (_ page 42) and
you're listening through your TV speakers.
- the AV receiver is muted.
• Speakers that you set to "No" or "None" in the "Sp Coufig
(Speaker Configuration)" (_ page 36) cannot be selected.
Erl
37