Filter
Top Products
- 56 -
18. MIC / INT MIC label
The MIC label appears when external micro-
phones are selected.
The INT MIC label appears when input se-
lected for recording is the internal micro-
phone.
19. LINE label
The LINE label appears when input(s) se-
lected for recording is (are) the LINE IN jacks.
20. Record
The Record symbol appears when the
PMD671 is in record mode. It appears with
the Play symbol when recording. It appears
with the pause symbol and flashing when in
record pause.
21. Play
The Play symbol appears when the PMD671
is in playback, playback pause, recording or
record pause.
22. Pause
The Pause symbol appears when the
PMD671 is in playback pause or record
pause.
23. Battery
When on battery power, the Battery symbol
appears in most displays to indicate battery
charge.
indicates that the battery charge is good.
indicates that the battery charge is getting
low and there is approximately 5 to 10 min-
utes of record or playback time available.
18 19 20 21 22 23 24 25 26
flashing indicates that the battery has
approximately 1 to 3 minutes of record or
playback time remaining.
The CHARGE indicator light will flash. If
BEEP is set to On, the PMD671 will also
beep.
If the PMD671 continues to operate, it will
automatically shut down. If recording, it will
write track information, stop recording and
power off. If in playback, it will stop playback
and power off.
indicates that the battery charge is de-
pleted.
24. S.SKIP label
The S.Skip label appears when Silent Skip is
enabled.
25. Margin level
The Margin level is displayed. The PMD671
holds this display at the highest level
achieved during the current recording. If
more than 0 dB, OV is displayed. To reset
the Margin level, press and release the
MARGIN RESET button.
26. -dB label
The -dB label applies to the Peak level
display.
Care and Maintenance
MARK
TRACK
TOTALTRACKTIME
REC REMAIN kbps
A-B
L
R
-dB
PM
kHz
AM
INT
MIC
LINE
S.SKIP
-dB
over
0
26
12
20
40
00
Use a soft cloth slightly moistened with mild
detergent solution.