Filter
Top Products
29
ENGLISH
29
Specifications
n Audio performance
• Analog output
Channels: 2 channels
Playable frequency range: 2 Hz – 20 kHz
Playable frequency response: 2 Hz – 20 kHz
S/N: 110 dB
Dynamic range: 100 dB
Harmonic distortion: 0.002 % (1 kHz)
Wow & flutter: Crystal accuracy
• Output level
Signal type: 2.2 V RMS stereo
Headphone output: 28 mW/32 Ω (variable maximum)
• Digital output
output level (cinch JACK): 0.5 Vp-p (75 Ω)
output level (optical): -19 dBm
• Optical Readout System
Laser: AlGaAs
Wave length: 780 nm
Signal type: 16-bit linear PCM
Sampling frequency: 44.1 kHz
n General
Power supply: AC 120 V, 60 Hz
Power consumption: 32 W
Standby: 0.3 W or less
Operating temperatures: +5 ˚C – +35 ˚C
Operating humidity: 5 – 90 % (without dew)
z For purposes of improvement, specifications and design are subject to change without notice.
Problem Cause Corrective action Page
Sound cannot be heard
even when an iPod is
connected.
•Models prior to 5th generation
iPods are not supported.
•For details, see “Supported
iPod Models”.
14
•The amplifier and speakers are
not connected correctly.
•Connect the cables correctly.
(See the instruction manual
for the amplifier.)
14
•The amplifier’s function or
selector switch is not set to
“CD” or “AUX” or such (to
whatever you have connected
this unit to).
•Switch the amplifier’s
function or selector switch
to “CD” or “AUX” or such
(to whatever you have
connected this unit to).
(See the instruction manual
for the amplifier.)
–
•The amplifier’s volume control
is set at the minimum level.
•Adjust the amplifier volume.
(See the instruction manual
for the amplifier.)
–
It takes time for USB
memory device to be
read.
•When connecting a high-
capacity USB memory device,
it will take time to read
depending on its capacity.
Several minutes may be
required for reading when
using a high-capacity device.
•Wait until reading is
completed.
–
There is no sound output
from this unit when
music files stored on a
USB memory device or
iPod are played.
•The “USB OUT” setting is set
to “2 Digital”.
•Change the “USB OUT”
setting to “1 Analog”.
20
GRemote controlH
Problem Cause Corrective action Page
Remote control
operation is not
possible.
•The distance between this unit
and the remote control is too
great.
•Move closer to this unit, and
operate the remote control
within the operating range.
4
•There is an obstacle between
this unit and the remote
control.
•Remove the obstacle. 4
•The remote control’s batteries
are dead.
•Replace all batteries with
new ones.
4
•The remote control sensor is
being subjected to strong light.
•Move so that the remote
control sensor is not
subjected to strong light.
4
•The switch on the back of the
REMOTE CONTROL is on
“EXTERNAL”.
•When using this unit
independently, set the
switch to “INTERNAL”.
14
1.CD6004U_ENG_02A_0706.indd 29 2011/07/14 15:56:46