Filter
Top Products
Components and Parts
Please take a moment to familiarize yourself with all of the parts.
This will help you as you progress through the manual, and as you set up the system.
SMS1-System
Figure 1 – SMS1 System Components
1 - SMS1-SUB - This is the Subwoofer Module. It houses the Low Frequency Loudspeaker, one 120
Watt amplifier for the Subwoofer, two 20 Watt amplifiers for the Satellites, and the Soundzone
Electronics. Please see Figure 2 for more detail on the Subwoofer Module.
2 - SMS1-SAT – There are four Satellites in a complete system. These are the loudspeakers for all of the
middle and higher frequencies.
3 - InvisiBall – There are four of these in a complete system. They are the only hardware you need for
installing the SMS1 -SAT’s on a solid surface.
4 - Hex Key Wrench - This INCLUDED 3mm Hex Wrench is used for loosening and tightening the
InvisiBall mechanism in the SMS1-SAT’s.
5 - Wrench – This INCLUDED Wrench is for tightening the InvisiBall Arm onto the base.
6 - Block Connectors – These Block Connectors are provided for making all input and output connections
from the Connector Panel.
7 - Security Panel – Covers the tuning controls after setup to prevent tampering.
8 - Power Cord – This cord attaches to the IEC Power Input Jack on the Electronics module and connects
to an AC Power Outlet for supplying power to the module.
9 - Subwoofer Feet – There are two feet in a complete system. They are required if the Subwoofer is to
be set on a floor or shelf.
3