19
POWER CAPABILITY
SMS1-Sub:
SMS1-Sat:
SPL Capability (1W, 1m):
SMS1-Sub:
SMS1-Sat:
INPUTS
Music (use only one of the following):
Microphone:
Internal Crossover:
Remote Volume Control Jack:
SETTINGS
Protected Controls
Subwoofer Polarity:
Crossover:
Bass Trim:
AutoWarmth:
Page Threshold:
Speaker EQ:
User Accessible Controls:
Music:
Mic:
MODELS:
SMS1
SMS1-WH
SMS1/230
SMS1-WH/230
SMS1-SUB
SMS1-SUB-WH
SMS1-SUB/230
SMS1-SUB-WH/230
OPTIONAL ACCESSORIES:
Z-M1 Paging Microphone:
ZR-V Remote Wallplate:
ZR-IWB In-Wall Electrical Box:
ZR0OSB On-Surface Electrical Box:
80 Watts Continuous pink noise
160 Watts Continuous program
240 Watts Continuous peak
10 Watts Continuous pink noise (x 4 speakers)
20 Watts Continuous program (x 4 speakers)
40 Watts Continuous peak (x 4 speakers0
104 dB average, 108 dB peak.
92 dB average, 98 dB peak (x 4 speakers)
Pro Line Level Input: +4 dBu nominal, balanced, Euroblock connector
Consumer Line Level Input: =10 dBV nominal, unbalanced, RCA connector.
(See Note 1, below if using the Consumer Line Input)
Speaker Level Input: For 70V or 100V speaker lines, Euroblock connector
Balanced, Euroblock connector, switchable phantom power for condenser
microphones. Band limited 200 Hz – 8 kHz
24 dB/oct low-pass to the subwoofer amp/driver.
24 dB/oct high-pass to the satellite amp/speakers.
RJ45 connector, for standard UTP Category 5 cable. Uses ZR-V remote wallplate.
Sets the polarity of the input signals so the bass to the subwoofer adds properly.
Positions:
In Polarity (Normal)
Out of Polarity.
Sets the crossover frequency of the subwoofer.
Positions:
160 Hz (Normal) – for normal operation of SMS1 system.
80 Hz – when using SMS1 Sub to augment the bass of another speaker
system, to avoid muddy overlap with fullrange speakers.
Adjusts subwoofer level relative to that of the satellite speakers.
Control: Variable rotary control
AutoWarmth automatically adjusts tonal balance to sound full at low volumes.
Indicator: LED, lights when AutoWarmth is activated.
Control: Variable rotary control
Adjusts threshold where microphone signal triggers music ducking.
Built-in EQ is specifically set up for SMS1-Sats.
Positions: On (Normal), Off
Adjusts volume of music source
Adjusts volume of the paging microphone
Charcoal Gray, 120 VAC
White, 120 VAC
Charcoal Gray, 230 VAC
White, 230 VAC
Powered Subwoofer, Charcoal Gray, 120 VAC
Powered Subwoofer, White, 120 VAC
Powered Subwoofer, Charcoal Gray, 230 VAC
Powered Subwoofer, White, 230 VAC
Dynamic (leave phantom power off), 600 ohms, balanced
Wallplate for remote adjustment of music volume
U.S. Size electrical box for use with ZR-V. For countries where U.S. size boxes
are not be available. Contains side dogear clamps to clamp onto wall surface.
U.S. Size electrical box for use with ZR-V. For countries where U.S. size boxes
may not be available. Mounts on the surface of the wall.
Specifications
Note 1: If positioning of the Subwoofer requires the use of a long unbalanced (RCA) input cable for the
music, then buffering and/or balancing of the signal via an external device at the source might be
necessary in order to make sure the audio fidelity is not compromised before getting to the SMS1 system.