Filter
Top Products
Step 5: Remove the logo badge from the SMS1-SAT, insert the INCLUDED 3mm hex key, loosen
the InvisiBall clamp by turning the hex key counter-clockwise and place the InvisiBall Receptacle
over the Ball.
Step 6: Turn the hex key CLOCKWISE until the mechanism begins to clamp down on the
InvisiBall.
Step 7: Before the mechanism is fully tightened, aim the SMS1-SAT on the ball. Then tighten the
mechanism until it holds the speaker in place.
Step 8: Replace the Logo Badge on the front of the Satellite.
Step 9: Connect the speaker wires to the speaker observing correct polarity. The Red terminal is
the Positive.
Step 10: Wire management clips are included. Insert the speaker wire into the clip and fasten the
clip onto the Invisiball Shaft.
Figure 12 – Wire Management Clips
NOTE: The same InvisiBall arms can be used for ceiling mounting the SMS1-SAT.
15