Filter
Top Products
Basic Operations
36
When you want to check the counter during playback, there are several ways to do it.
Pressing DISPLAY will cycle you through the three options.
Press DISPLAY just once to see the counter, mode, time, date and tape speed on the
screen for 5 seconds.
Before the 5 seconds is up, press DISPLAY a second time to see just the counter. It
will stay on the screen.
Press DISPLAY a third time to to see the counter on the VCR display as well.
Press DISPLAY a fourth time to end the on-screen display.
The linear time counter operates only if there is something recorded on the tape.
The counter changes to 0:00:00 when the tape is ejected.
Marking with the Time Counter
If there is one part of the video that you know you are going to want to return to, you can
set the time counter to memorize that spot. Begin in either STOP or PLAY mode.
Press DISPLAY twice to show the counter on the TV screen.
Begin recording or playing back a tape. Notice the counter remains on the screen.
At the point that you want to go back to, press CLEAR. This resets the counter to
0:00:00.
Press STOP when you are done recording or playing back the tape.
Press DISPLAY again and an "M" will display below the counter on the TV screen.
This indicates that the counter's memory function is engaged.
Now when you rewind the tape, it will automatically stop at the spot where you cleared
the counter. (Notice it moves just past the marker and then back to it.) Press PLAY to
watch the tape from that preselected spot.
Press DISPLAY to take the counter display off. The spot is still in memory until you
set a new one or until the tape is ejected.
Jump to an Index Mark with INDEX
A quick way to access specific program segments is with the index search feature. This
lets you move through a tape that has several recordings on it by searching for the
INDEX "mark." This function only works with recordings that have been set up with
indexing. You create an INDEX mark every time you press the REC button while
recording. For more on how this gets recorded, see the section on Recording a Program
(page 37).
This VCR's indexing system is based on the VHS Index Search System (VISS). The
new system may not recognize index marks on tapes recorded on older VCRs.
If the VCR is in PLAY mode, press STOP.
Press DISPLAY. This brings up the Index Screen.